Toyota Air Cleaner Assemblies
A/C System Information Label
Mass Air Flow Sensor Bolt
Drive Motor Inverter Cooler Water Pump Bolt
Clamp or Clip
Case; Plate
Upper Cover Tape
HVAC Blower Case Assembly
Hose
No results found for "Air Cleaner Assembly, Air Cleaner". Here are some helpful search tips:
- Search by a part name. Example: water pump.
- Be less specific. Example: brake instead of ceramic brake.
- Remove information such as make, year or model.
- Can't find the part you are looking for? Contact us and we'll find it for you!
An Expert Guide to Replacing Air Cleaner Assemblies
The air cleaner assembly serves as the primary barrier against the microscopic dust and grit that can ruin your cylinder walls. For owners of the efficient Toyota Corolla, a cracked or warped air cleaner housing can lead to "unmetered" air entering the system, causing lean-run conditions and poor fuel economy.
Easy Steps to Replace Your Toyota's Air Cleaner Assembly
1. Secure the Battery
Disconnect the negative terminal to prevent electrical arcs while working near sensitive electronic sensors and harnesses.
2. Unplug the MAF Sensor
Gently press the plastic tab on the electrical connector to release the sensor harness; take care not to pull on the delicate wires.
3. Remove Intake Snorkel
Loosen the worm-gear clamps anchoring the flexible rubber intake boot to the air cleaner housing and slide the hose away.
4. Extract Mounting Bolts
Unscrew the three or four structural bolts anchoring the base of the air cleaner assembly to the vehicle’s frame or inner fender.
5. Seat the New Housing
Position the fresh genuine OEM assembly and hand-start the bolts to ensure the clinical alignment of the intake and vacuum ports.
6. Re-Torque All Hardware
Tighten the clamps and bolts to Toyota’s specific torque settings, then reconnect the sensor to verify a 100% airtight system.
Restore Peak Engine Operation at Toyota San Diego Parts
To find the exact genuine air cleaner assembly parts for your Toyota, contact us today.